JavaScript seems to be disabled in your browser.

You must have JavaScript enabled in your browser to utilize the functionality of this website. Click here for instructions on enabling javascript in your browser.

NEW BLUE POWER IP22 BATTERY CHARGER WITH 3 OUTPUTS THE GREATEST EFFICIENCY HAS ALREADY BEEN ACHIEVED! WITH EFFICIENCY OF UP TO 94%, THESE CHARGERS GENERATE UP TO FOUR TIMES LESS HEAT IN COMPARISON WITH THE SECTOR STANDARD. AND ONCE THE BATTERY IS COMPLETELY CHARGED, THE CONSUMPTION IS REDUCED TO 0.5 WATTS, BETWEEN FIVE AND TEN TIMES LESS THAN THE SECTOR STANDARD. High efficiency With up to 94% efficiency, these chargers generate up to four times less heat compared to industry standard. And once fully charged the battery, consumption is reduced to 0.5 watts, between five and ten times less than industry standard. 6-stage adaptive load algorithm: checking - initial loading - absorption - reconditioning - flotation - storage The Blue Power charger has "adaptive" management of the microprocessor controlled battery. Its "adaptive" function will automatically optimize the charging process based on the use of the battery. Storage mode: less aging and need for maintenance when the battery is not being used The storage mode is activated when the battery has not been discharged within 24 hours. In storage mode, the float voltage is reduced to 2.2 V / cell (13.2 V for 12 V batteries) to reduce gassing and corrosion of the positive plates. Once a week, the voltage is raised again at absorption level to "equalize" the battery. This function prevents electrolyte stratification and sulfation, the main causes of battery failure. It also charges Li-Ion batteries (LiFePO4) LiFePO4 batteries are charged with a simple initial charge - absorption - float algorithm. Set NIGHT and LOW. When the NIGHT or LOW modes are active, the output current is reduced to a maximum of 25% of the nominal output and the charger will be completely silent. The NIGHT mode ends automatically after 8 hours. The LOW mode can be finalized manually. Protection against overheating The output current will decrease as the temperature rises to 50oC, but the Blue Power charger will not fail. Eleven LED status indicators Load algorithm: TEST / BULK (initial load) / ABSORPTION / RECONDITION / FLOAT / STORAGE / READY MODE button to adjust: NORMAL (14.4 V) / HIGH (14.7 V) / RECONDITION / LI-ION